Wasp CCD Scanner Manuale Utente Scaricare il pdf (Pagina 8)

Chapter 5

CCD Setup & Configuration

In order to configure the Wasp CCD scanner, you must familiarize yourself with

the setup procedures on the following pages. The default settings of the Wasp

CCD scanner are identified on each page and clearly marked with an asterisk

(*). The default settings have been preprogrammed for the most common

bar code configurations. Use the CCD Setup & Configuration only to

customize the Wasp CCD settings. If you need to configure the Wasp CCD

reader, the default settings will be overwritten. All the programmed settings are

stored permanently in non-volatile memory. Therefore, your configuration will be

maintained even if keyboard power to the Wasp CCD scanner is removed by

turning off your PC.

In order to configure the Wasp CCD, three basic steps need to be followed for

each programmed setting:

(1) Scan the 'Begin' bar code with the Wasp CCD reader to select

your configuration

(2) Scan the appropriate setting(s) to customize the CCD configuration

(3) Scan the corresponding 'End' bar code with the Wasp CCD reader

Note: If you are unsure whether or not you have programmed the scanner

properly, return to page 6 and return the scanner back to the default settings.

Then begin the configuration process again.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 30 31

Nessun commento

Wasp CCD Scanner Manuale Utente Pagina 8